SEGA Dreamcast GDEMU Tray Insert V0 – For Version 0

Description

If you aren’t absolutely sure your console is a V0 please do not buy this mount. You probably want the regular V1 or V2 mount

For the V0 Console you should probably be doing the resistor mod to step down the voltage before adding a GDEMU.

What’s included:

3D printed GDEMU tray insert piece, button, GDEMU mounting bracket, screws and SD Extension Cable.

Other Notes

• This top loading tray puts the SD card as far forward as possible for the easiest access
• This has all screws you need to complete your installation, no need to worry if you don’t have those old screws from your GD-ROM drive
• Works with clone or regular GDEMU
• Easily screws into the bottom of your Dreamcast Shell
• Full sized SD card access on the top of the Dreamcast
• Colors not listed may be available upon request
• Compatible with other Dreamcast mods such as noctua fan or pico PSU

To Install:

A detailed post with photos and a video is available here but the short version is listed below:

1. Secure GDEMU to GDEMU support with provided screws and washers but do not fully tighten.
2. Place into console and plug in GDEMU.
3. Secure support to console with old GDROM screw.
4. Tighten screws for GDEMU
5. Screw in the SD extender into top insert with the provided screws
6. Secure the top insert to the lid piece using the three provided screws.
7. Plug in the SD extension cable.
8. Reassemble your dreamcast, insert the button, and your done!